Detectors

Series II Ion Lens for ELAN^® 6x00, 9000, DCR-e, and DRC II ICP-MS series instruments manufactured between January 1998 and April 2005.

Replacement Cassette Lens ShadowStop^™ for ELAN^® 9000, DRC-e, and DRC II ICP-MS series instruments manufactured after April 2005.

Mist filters capture oil mist from outlet of pumps; which would otherwise be ejected into the atmosphere. Supplied with NW25 clamp, centering ring, and O-Ring. NW25 to 3/4 inch BSP adapter.

This kit contains: 0.035 in., 1.5 mm, 2 mm, 2.5 mm, 3 mm, 4 mm, 5 mm, 5.5 mm, 6 mm Allen keys, metal tweezers, open end wrench 3.2 mm x 4 mm, open end wrench 5.5 mm x 7 mm, and a 6 in. adjustable end wrench.

The mobile phase in gas chromatography transports analytes through the column, between the injector and detector, when the analytes are not partitioned into the stationary phase. This gas purifier removes hydrocarbons, moisture, and oxygen. Specifically for helium gas.

For use in desiccants or an as absorbent. Can be used as a filter of fluoride, arsenic, and selenium in water. Highly porous material excellent for absorbence.

For use with volumetric bubble flowmeters. Also useful for checking gas delivery system plumbing for leaks. Not recommend for use upstream of capillary GC systems (an electronic leak detector is preferred).

The dual -stage detector is an integral part of the NexION ICP-MS SimulScan^™ system. This discrete dynode electron multiplier measures both high- and low-level analytes simultaneously.

This kit contains: gas line assy, Allen key 5/64, hole plug - 0.486 DIA NYL, trap 11.5 LG, restrictor A2 air FID/PHOS, and regulator-9000 H2 ON/OFF.

Replacement glow plug for Gas Chromatorgaphy with Flame Ionization Detector (FID).

The PID utilizes a high-intensity ultraviolet light source to ionize the sample components eluting from the column in order to generate the chromatographic signal.

The PID has a maximum recommended operating temperature of 250 °C. The lamp can be replaced with a blanking disk to allow bake-out operation (up to 350 °C). Kit includes: detector, heater, sensor, makeup gas needle valve, and all necessary mounting hardware for installation on a GC. Requires, but does not include, amplifier (N6120061) and lamp power supply (N6120062). Firmware revision 1.2 or greater is required. Firmware must be PerkinElmer Service installed. Improved selectivity for multiple ring aromatic, sulfur compounds.

Includes parts required to add PPC controlled make-up gas to an existing Thermal Conductivity Detector (TCD). Includes tubing, tee-piece, PPC pneumatics module and PPC fri t#4 (P/N N6120155). Requires PPC capability in PerkinElmer AutoSystem XL GC.

Kit includes detector assembly with heater and sensor, heater block, igniter, hydrogen pressure regulator and needle valve. Requires but does not include amplifier (P/N N6120162). Requires PerkinElmer AutoSystem XL to have firmware revision 3.3 or higher. Note: PerkinElmer AutoSystem XL GO'S shipped prior to January 1997 require a new detector cover.